Axis 1 (Spindle)
Spindle Weight Capacity:	454 kg. (1000 lbs.)
Maximum Spindle Swing Diameter:	864 mm (34 in.)
Rated Spindle Torque:	500 Nm (4425 in./lbs.)
Spindle Stall Torque:	825 Nm (7300 in./lbs.)
Maximum Spindle Speed:	120 RPM
Spindle Height Above Floor:	1102 mm (43 in.)
3-Jaw Chuck Size:	305 mm (12 in.)
Live Tail-stock Center Size:	#4 Morse taper
Axis 2 (Horizontal Carriage)
Nominal Winding Length Capacity:	2400 mm (96 in.)
(Note: Winding length capacity varies depending on number of axes used, winding angle, and part configuration.)
Mandrel Length Capacity:	5410 mm (213 in.)
Useable Carriage Stroke:	3100 mm (122 in.)
Carriage Pull (continuous rating):	91 kg-f (200 lbf.)
Maximum Carriage Speed:	1524 mm/sec. (60 in./sec.)
Carriage Drive Capacity:	113 kgf. (250 lbf.)
Carriage Stall Force:	160 kgf. (352 lbf.)
Carriage Drive System:	Rack and Pinion
Axis 3 (Optional) (Radial Carriage)
Radial Carriage Stroke:	457 mm (18 in.)
Radial Carriage Speed:	610 mm/sec. (24 in./sec.)
Radial Carriage Drive System:	Ballscrew
Axis 4 (Optional) (Rotating Eye)
Rotating Eye Range:	+/- 180 degrees
Rotating Eye Speed:	400 deg./sec.
Rotating Eye Inside Diameter:	168 mm (6.63 in>)
Electrical
Electrical Power Requirement:	400 V, 3 Ph., 50 Hz. (480 V, 3 Ph., 60 Hz.)
Electrical Enclosures:	NEMA 12
Drives and Motors:	Permanent magnet AC servo
General
Winding Angle Capacity:	0 - 90 deg.
Repeatable Winding Accuracy:	.25mm (.010 in.) (Standard deviation at 6 in. diameter, excluding tow and delivery error)
Machine Size (lg., wd., ht.):	5620 x 1546 x 2412 mm (221 x 61 x 95 in.)
Machine comes with swivel lift eyes for handling. 6 inch (150 mm) minimum reinforced concrete floor thickness recommended. Machine general configuration is single spindle horizontal. Carriage beam is offset to allow overhead hoist access to spindle. Standard delivery system is comb and 'D'-ring, 20-roving maximum capacity. Machine is rated continuous-duty service. Machine finish: Polyamide epoxy paint, Entec blue (RAL #5023) mainframe with moving parts yellow.